HOME

EVENTS

NEWS

PRODUCTS

LINKS

CONTACTS

 ~
New Complete Sterndrive replacements for
Mercruiser Alpha I, R, & MR *, vintage 1973 thru 1990 **.

Only $1,195.00 cash USD

(plus freight and taxes, where applicable)
Limited supply at this price. Call for details.
Shipped in two cartons to prevent shipping damage.
Gear lube, zincs, plastic water tube guide, brass intermediate shift shaft, stainless nuts to assemble the two halves, stern drive installation gasket set, shop supplies, professional assembly and installation are additional.

Includes a 1 year limited warranty, even if you install it yourself.

(Optional assembly and installation kit for above includes; plastic water tube guide, brass intermediate shift shaft, stainless nuts to assemble the two halves and drive installation gaskets. You do not need this kit to assemble the two halves. You can easily remove these items from your old sterndrive. In that case, order just the sterndrive installation gasket kit.)

Are you looking for a...1991 & up, Alpha I, Gen II?

IN HOUSE SPECIAL!
Bring your boat in to our service shop in San Diego and have one of the above mentioned completely new sterndrives professionally assembled, installed, and tested for $1,696.27 plus tax.

Just need a New upper half or a New lower unit?
Upper unit: $595
lower unit: $695
(plus freight and taxes, where applicable)
Limited supply at this price. Call for details.
Gear lube, zincs, plastic water tube guide, brass intermediate shift shaft, stainless nuts to assemble the two halves, stern drive installation gasket set, shop supplies, professional assembly and installation are additional.

Includes a 1 year limited warranty, even if you install it yourself.

Call 858 866-1525 today

  * (The above mentioned sterndrive units are not manufactured by Mercury Marine and/or Mercruiser. R/MR/Alpha I & GEN II are trademarks of the Brunswick Corporation. The manufacturer of these drive units is not affiliate with the OEM.)

** (Can be installed on older pre-1983 transom assemblies, call us for information. Ratios available: 1.47 (20/22), 1.62 (24/24), 1.81 (17/19), 1.94 (20/24) )

Assembly information: The upper and lower units are fully assembled and shipped separately, ready to be joined together. Some basic hand tools are required. (5/8" socket wrench with 3" extension, 5/8" open end wrench, pliers, straight blade screwdriver, small grease gun, and in some cases a 9/16" socket or open end wrench and a gasket scraper.) Shop supplies required: Mercruiser HP gear lube or equivalent, gasket sealing compound, bellows adhesive, spline grease, rags, and a service manual. Unit assembly, installation, and maintenance information and procedures are  identical to those found in the Mercruiser service manual. 
Special Note: When replacing only half of a sterndrive unit with a new section, the section being re-used must be internally inspected and cleaned in order to prevent sterndrive failure and/or damage to the new section. If the unit is assembled incorrectly and/or operated without proper lubricant, internal damage will occur which is not covered by the warranty.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

   We also have new, used, and remanufactured stern drives for Mercruiser, OMC, OMC Cobra, Volvo, and Volvo SX product. In addition, we sell and install outboard lower units for Force, Johnson/Evinrude, Mercury Marine, and Yamaha.

Give us the opportunity to offer you a quote. 

   Don't need a complete sterndrive replacement? Just a minor repair or seal replacement? Our factory trained and master mechanics for Mercruiser, OMC, OMC Cobra, Volvo and Volvo SX product will diagnose and perform the repair correctly, the first time.